Technical Specifications

SUNSYNK G83 600W Grid Tie Inverter

After 3 years extensive research & development our low cost inverter has been approved by Intertek (The World's largest test laboratory) to all the following standards:

Specifications

  • Approved for continuous running 400 Watt Can connect to 600 Watt PV Panel
  • Class 2 IP 20
  • V Max ( Absolute Input V ) 60 Volts
  • Voltage range 22v to 60v DC
  • MPPT ( Max Power Point Track range ) 28 - 58V DC
  • Isc PV ( Absolute max PV short circuit current is 20A )
  • Maximum continuous PV Current 16.3 Amp

Output

  • Nominal 50 Hz 230 Volt
  • Rated max continuous AC Current 1.8 Amp
  • AC Out put range is 209 - 258 Volts
  • AC Output frequency range is 49.5 Hz to 50.5 Hz
  • Power Factor is > 0.98
  • Max Efficiency is > 92%
  • Standby Consumption is < 0.5 Watt

Protection

  • Over Current Protection
  • Reverse polarity protection
  • Over temperature protection
  • Operating Temperature - 20'C to + 30'C UV Stabilized Polycarbonate case
  • LED Status indicators array

1 x Red LED ( Indicated Fault )

3 x Green LED will start to cycle from left to right when the inverter starts to function. The quicker it cycles the more power the inverter is supplying. Island Protection ( No Grid then the RED LED will indicate ) AC voltage or frequency is out of range then the RED led will also be lit. If the DC input voltage is out of the working range the RED LED will flash. If the unit is not generating power the Green LED will not cycle.

Stackable

  • Unlimited

Easy to Install

  • Install panels (1)
  • Connect cable to SUNSYNK box (2)
  • Plug directly into any mains power socket (3)